Install the brake line (and ABS) bracket.
)
This step involves drilling into the frame. The exact location is hard to describe so look at the picture taken from the passenger side and note the hole (yellow arrow). Fabtech includes 5/16" bolts for holding the bracket to the frame so I used a 9/32" drill bit. Fabtech also says to use these 5/16" bolts for tapping this hole... I say good luck! If you want to get these bolts into the hole and stay there then you'll need to tap threads into it. I used a 5/16" tap.
)
Locate the supplied FTS70022 bracket. It's silver and shaped like an 'L'. You'll also need a 5/16" bolt, adel clamp, and a 1/4" nut, bolt, and washer. Attach the bracket to the frame using the 5/16" bolt (with Lock tite) and then attach the lines to the bracket using the rest of the hardware. Your setup should look similar to the picture when you're finished.
After you've done both sides, you can install the brake rotors, calipers, and bearing dust covers. If the truck is equipped with ABS, reinstall the factory ABS sensor into the Fabtech knuckle. If the truck does not have ABS, locate the supplied ABS caps and attach them to the knuckle with 6mm bolts and splt washers. They are the tear-drop shaped plastic pieces.
