Install the Bearing/Seal Flange
)
Remove the saran wrap (or whatever you used to protect the transfer case output bearing) from the transfer case output shaft.
Clean the surface near the bearing making sure there is no leftover residue from when the tailcone was removed.
Use three grade 8 M10 x 25mm bolts to install the Bearing/Seal Flange onto the transfer case. Apply Loc-Tite to the bolts before inserting them.
Now would be a good time to apply RTV silicone to the remaining splines of the output shaft. This is to prevent oil from leaking through the CV Output Flange once it's installed.
